LicPoll would fail to parse the IBM LUM license information correct
when there were offline usage.

LicPoll would fail to get correct host (node) name when parsing IBM
LUM output, if the host name was followed by ip address.

When running lmutil, it has proven to fail in some cases if current directory
is not that of the license file. LicPoll now runs lmutil for each license file
from that license file's directory.

If installed on the FLEXlm server, LicPoll is now able to scan the
Registry in order to locate the license files available on the server.

Output from i4blt (IBM LUM status command) can contain numerical
month value, rather than short month name. This patch will allow
LicPoll to handle both formats.

Minor variations in output from FLEXlm status command (depending on version
of FLEX) caused a parsing error. The output contains long lines of dashes,
which licpoll didn't handle very well.

When licpoll starts to poll, it will align the poll time according to the poll
interval. If the interval is 5 minutes, then polls will be taken on the hour,
5 minutes past, 10 minutes, etc. When licpoll was started, if only seconds past
the hour, the first poll would be aligned to 5 minutes past. This patch fixes
this, so that the first poll is taken immediately after startup, and then the
polls are aligned as normal (5, 10, 15, etc.).

Added support for newly discovered format on output from i4blt -s -lc (slightly
different from previously known output format).